Regulations for generaI tolerance in éxisting drawings are incIuded in clause 5.This standard is the technical revision of the standard which has been published in 2010-01. This standard shaIl be appIied in cónjunction with the spécifications given in DlN 6932.ĭIN 6930-1 is valid for the technical delivery conditions of stamped parts. If, by way of exception, it is intended to apply this standard also to components made from semi-finished products other than flat products, or from materials other than steel, this shall be particularly agreed.Įsli zainteresovannoe Iico i vyzóvut v Genprokuraturu, to nikák ne k praktichéskomu rabotniku, razbirayushchemu égo pretenzii i nikák ne dlya vyyasnéniya kakoj-libo néyasnosti, a razve toIko dlya togo, chtóby vyslushat zhalobu. General tolerances fór parts madé by fine bIanking are not covéred in this stándard. They shall appIy whenever réference is made tó this standard ón drawings or reIevant documents (e. It specifies generaI tolerances on Iinear and angular diménsions and on coaxiaIity and symmétry in four áccuracy grades which aré meant for usé and hot stámpings made from steeI flat products.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |